Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 480

Normal set_sky_writing_mode_list
List Command
Function identical with
Call
set_sky_writing_mode_list( Mode )
Parameters
Mode
Comments • Unlike set_sky_writing_mode, the command set_sky_writing_mode_list lets you
activate or deactivate Sky Writing mode 2 or 3 (switching to or from Mode = 2 or 3) even
within a list. Here, a temporary switch to Sky Writing mode 1 occurs.
• Deactivation of Sky Writing mode 1 via set_sky_writing_mode_list (switching from
Mode = 1 to 0) results in the addition of a mark delay defined prior to activation of Sky
Writing – provided that no other delay is in effect (e.g. a jump delay).
® ®
RTC 4 RTC 5 new command
Version info • Available beginning with version DLL 527, OUT 529, RBF 519
• Last change with version DLL 531, OUT 532: mode 3
References set_sky_writing_mode
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
set_sky_writing_mode (see above), but a list command
See set_sky_writing_mode.
480