Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 613

Changes from revision 1.2 to revision 1.3
Page Name of section / command
52 "McBSP Interface"
84 "Matching of Short-Command
Counts (as of Version DLL 523,
OUT 524)"
96 chapter 7.1.3 "Marking Points"
102 Notes in section "Mark Delay"
107 Automatic Delay Adjustments
123 Notes in section Assigning Loaded
Correction Tables
124 Correction File Header
165 chapter 8.3 "Online Positioning"
216 chapter 9.3.4
230, apply_mcbsp command and
231 apply_mcbsp_list
275, get_mcbsp command and
276 get_mcbsp_list command
328 load_correction_file
370 move_to command
375 para_laser_on_pulses_list
command
388 read_mcbsp command
416 set_dsp_mode command
427... set_fly_rot_pos,
432 set_fly_y_pos
457... set_mcbsp_rot,
459 set_mcbsp_rot_list,
set_mcbsp_x, set_mcbsp_x_list,
set_mcbsp_y, set_mcbsp_y_list
®
RTC 5 PC Interface Board
Rev. 1.9 e
18 Revision History
Change
Changes and additions (as of version OUT 526):
• Stagnation of data transmission no longer occurs.
• Data transmission for online positioning
Added
Added
as of RTC5OUT.out version 526: changed behavior of timed
mark or arc commands with zero spacial length (also see
notes in
page
Change (as of version DLL 522, OUT 522, RBF 517):
• in section (1): If LaserOff overlaps LaserOn, then the LaserOff
delay still gets automatically extended, but only so that the laser
control signals remain on for 0.5 µs (instead of 10 µs).
• in section (2): If a LaserOff delay expires and simultaneously a
LaserOn delay should again be set, then an additional scanner
delay (of 10 µs) will no longer be inserted.
Changed (as of version DLL 521, OUT 521):
load_correction_file
after loading a correction table.
Changed: Parameter 15 (get_head_para, get_table_para)
is 2.0 (instead of 1.0) for 'field size clipped'.
Added
Added (as of version OUT 526): online positioning
Added
command
Change (as of version OUT 526): see "Version info" in the
command description
command Changed (as of version DLL 521, OUT 521):
load_correction_file
after loading a correction table.
Added
Added
Added
Added
set_fly_x_pos and Added (as of version OUT 526): can't be used simultaneously
with online positioning
Added
chapter 8.10 "Timed Vector and Arc Commands",
198)
automatically calls
automatically calls
select_cor_table
select_cor_table
613