Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 605

18 Revision History
This list ignores spelling/grammar corrections, syntax reformulations or additions (such as new cross-refer-
ences) that don't affect the technical meaning. The supplied page numbers refer to this document.
Changes from revision 0.9 to revision 0.11
Page Name of section / command
22 chapter 1.2 "Identification"
44 chapter 4.3.3 "Data Cable (Optional)"
120 chapter 7.3.3 "Virtual Image Field"
200 chapter 8.11.3 "Determining
Reference Values"
210 External List Start
217 Normal, Short and Variable List
Commands and List Multi-
Commands
236 auto_cal command
322 list_nop command
407 set_auto_laser_control
415 set_delay_mode
420 set_end_of_list command
469 set_port_default
574 chapter 15 "Appendix A: The
®
RTC 5 PC/104-Plus Board"
®
RTC 5 PC Interface Board
Rev. 1.9 e
18 Revision History
Change
ID number is not written on the board
Recommend cable impedance added
Chapter added
(also usage for coordinate transformations)
Reference values for automatic self calibration are stored in
DLL or EEPROM
Information on master/slave synchronization with external
start and activated home jump
Expanded information on short list commands
Reference values for automatic self calibration are stored in
DLL or EEPROM
New comment
command Corrected: return value (error code) 5
command Corrected: RTC
Corrected: comments
command Corrected: comments
Chapter added
®
4 compatibility mode
605