Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 616

Changes from revision 1.4 to revision 1.5
Page Name of section / command
26 chapter 2.2.2 "Software"
and chapter 5.3 "Installing the Drivers"
57
53 chapter 4.4.7 "Stepper Motor
Control"
84 chapter 6.6.3 "Master/Slave
Operation"
113 chapter 7.2.4 "Sky Writing"
130 chapter "Scan-System-Error-Induced
Laser-Signal Auto-Suppression"
205 chapter 9.1.5 "Stepper Motor
Control"
273 get_marking_info
275 get_master_slave
282 get_stepper_status
296, goto_xy command,
297 goto_xyz command
311 laser_on_list command
328 load_correction_file
334 load_jump_table
335 load_jump_table_offset
479, set_sky_writing_mode
480 set_sky_writing_mode_list
command
set_sky_writing_para
481,
483 set_sky_writing_para_list
command
513 Stepper motor control commands:
... stepper_abs, stepper_abs_list,
522 stepper_abs_no,
stepper_abs_no_list,
stepper_control,
stepper_control_list,
stepper_enable,
stepper_enable_list, stepper_init,
stepper_rel, stepper_rel_list,
stepper_rel_no,
stepper_rel_no_list,
528 sync_slaves command
®
RTC 5 PC Interface Board
Rev. 1.9 e
18 Revision History
Change
and Warning added: Standby or sleep modes of the operating
system must be deactivated
Revised.
Corrected: An RTC
®
RTC 5 board is connected to its SLAVE (!) connector.
Revised and extended (Sky Writing mode 2)
Added.
Added.
command Added: now also returns the error bits of laser-signal auto-
suppression (bits#10...15 and 26...31).
command Corrected: master/slave recognition via bit#0 and 1
command Added.
Changed (as of version DLL 527, OUT 529): These
commands return only after motion has completed.
Corrected: The laser control signals will only turn off with a
subsequent list command.
command Changed (as of version DLL 527, OUT 529): The command
only returns after the jump to the corrected galvanometer
position has completed.
command Corrected: has no parameter Offset.
command Added: Function as described in version 1.4 for the
load_jump_table command (with parameter Offset).
command, Added
command, Upgraded: Sky Writing mode 2
Added.
stepper_wait
Corrected: An RTC
®
RTC 5 board is connected to its SLAVE (!) connector.
®
5 board is the master board if no further
®
5 board is the master board if no further
616