Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 592

16.1.4 Identification
The serial number of the RTC
printed on a white label attached to the board
(format: "RTC SN...").
The board's ID number and configuration are
described in the packaging list (also see
Accessories", page 29 and "Type Identification", page
575).
16.1.5 Type Identification
®
The ID number of the RTC
the board's factory-equipped jumper configuration
(JP1-JP8). The jumper configuration is additionally
encoded in a three-digit type code scheme. The type
code scheme is identical to that of the
®
RTC 5 PC interface board (see
16.1.6 Unpacking Instructions and
Typical Package Contents
 Carefully remove the RTC
the package.
 Keep the packaging, including the antistatic bag
®
the RTC 5-Express board is delivered in, so that in
case of repair the board can be properly
repackaged and returned to SCANLAB.
 Also remove all other articles from the package.
Check that all parts have been delivered. Refer to
the corresponding packaging list.
The package typically includes an RTC
board and a data CD (containing the corre-
sponding software (see below) and this manual).
Some product versions may also supply
additional components such as data cables or
converters (see "Optional Accessories", page
Delivered Software
The delivered software package is identical to the
®
RTC 5 software package (see
software drivers for Microsoft's WINDOWS 8,
WINDOWS 7, WINDOWS Vista and WINDOWS XP
(SP2 or higher) (32-bit or 64-bit) operating systems,
correction, DLL and program files, as well as utility
files for C, C++ and C#.
®
RTC 5 PC Interface Board
Rev. 1.9 e
®
16 Appendix B: The RTC 5-Express Board
®
5-Express board is
"Optional
5-Express board reveals
page 28).
®
5-Express board from
®
5-Express
576).
page 23). It contains
16.1.7 Optional Accessories
®
In addition to the RTC 5-Express board and its
software package, the following accessories – as with
®
the RTC 5 PC interface board – can be obtained from
SCANLAB (only hardware extensions from SCANLAB
should be used in combination with the RTC
Express board):
• XY2-100 converter (see
• Data cables (see page 29).
• Laser adapter (see page
• Slot cover with a 9-pin D-SUB connector for using
the 2. SCAN HEAD connector (see
• Slot cover with a 15-pin D-SUB connector for
using the MARKING ON THE FLY connector (see
page 51).
16.1.8 Supplementary Software
®
For customizing RTC correction files on the basis of
test measurements, SCANLAB offers the correXion5
program and its associated manual (also see
page 121).
®
5-
page 29).
29).
page 42).
592