Auto_Cal; Auto_Change - Scanlab RTC 5 PC Interface Board Installation And Operation Manual

Ctrl Command auto_cal
Comments • (As of version DLL 520:) ASC hardware checks are performed not just via
auto_cal(Command = 4), but also automatically for
– auto_cal(Command = 0) and
– the first call of auto_cal(Command = 1) and auto_cal(Command = 3) if neither
auto_cal(Command = 0) nor auto_cal(Command = 4) were previously executed.
In each case, the detected ASC hardware type gets stored in the RTC
can be subsequently queried via get_auto_cal. For automatic Command = 4 execution,
however, no corresponding return value is generated. The return value is instead simply
that of the primary Command call (see above).
When an error occurs, a corresponding error code will get saved to the RTC
(therefore,
is restored, you can clear the error from the RTC
auto_cal(command = 0) or auto_cal(command = 4). The error can't be cleared from the
®
RTC
® ®
RTC 4 RTC 5 The functions for automatic self-calibration (Command = 0 ...2) are (largely) unchanged
(see version info).
New: Command = 3 and Command = 4.
Version info Change with version DLL 520, OUT 519 (see
Last change with version DLL 535: Return value 8 (see above)
References set_hi, get_hi_pos,
Ctrl Command auto_change
Function activates a one-time automatic list change
Call

auto_change()

• The auto_change command is synonymous with auto_change_pos( 0 ). The subse-
Comments
quent list will then start at its beginning.
• Also see comments for auto_change_pos.
® ®
RTC 4 RTC 5 unchanged functionality
Version info Last change with version OUT 515
References auto_change_pos, get_status,
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
get_auto_cal won't return 100 or 200). As soon as hardware functionality
5 EEPROM by calling auto_cal(command = 1).
get_auto_cal
read_status
®
®
5 EEPROM by explicitly calling
page 612)
5's EEPROM and
®
5 EEPROM
238