Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 313

Variable laser_on_pulses_list
List Command
Comments • While the command is executed, the set position of the scanners is not changed. The
next list command will be executed when the programmed time interval Period has
passed.
• Wobbel mode (see
• Any softstarts that were defined will not be executed.
® ®
RTC 4 RTC 5 new command
Version info • Available beginning with version DLL 515, OUT 514, RBF 512
• Changed with version DLL 530, OUT 531, RBF 522: changed functionality for
31  Period  (2
2
References laser_on_list,
Ctrl Command laser_signal_off
Function turns off the "laser active" laser control signals immediately
Call
laser_signal_off()
Comments • This command is intended for direct laser control in combination with the command
laser_signal_on
• The command will be ignored
BUSY status is currently set, i.e. if a list is executing at the moment or if a list has been
halted via pause_list. In contrast, the command is executed when a list has been
paused via
currently set.
® ®
RTC 4 RTC 5 unchanged
References laser_signal_on
Normal laser_signal_off_list
List Command
Function same as
Call
laser_signal_off_list()
® ®
RTC 4 RTC 5 unchanged
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
page 167) will be retained, but will be ignored.
32
–1).
para_laser_on_pulses_list
(see below).
(get_last_error
set_wait (PAUSED status set) or when the board's INTERNAL-BUSY status is
laser_signal_off (see above), but a list command
return code: RTC5_BUSY) if the board's
313