Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 246

Ctrl Command control_command
(05
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
) Code Returned Data Signal Type
H L
25 Wavelength
H
Bits #4...19
Bits #0...3
26 Tuning number (as of Firmware Version 2078)
H
Bits #12...19
Bits #4...11
Bits #0...3
27 only after control_command(Data = 17FF
H
(e.g. via Code = 17FF
specified to be returned data type (as of Firmware Version 2078)
Bits #12...19
Bits #4...11
Bits #0...3
28 Current operational state (flags B15 ... B0):
H
Bit #19 (MSB) (B15)
Bit #18 (B14)
Bit #17 (B13)
Bit #16 (B12)
Bit #15 (B11)
Bit #14 (B10)
Bit #13 (B9)
Bit #12 (B8)
Bit #11 (B7)
Bit #10 (B6)
Bit #9 (B5)
Bit #8 (B4)
Bit #7 (B3)
Bit #6 (B2)
Bit #5 (B1)
Bit #4 (B0)
Bit #0...3
16
Wavelength / nm [0 ... 2 –1]
= 0
Start setting
Current setting
= 0
): Number of the internally
H
for reinstatement via Code = 1700
H
= 0
Temporarily stored setting
= 0
= 1: Galvanometer scanner's output stage is on
= 1: Galvanometer scanner heater's output stage is on
®
(always 0 for intelliSCAN 7, intellicube
scan systems with water-cooled scanners)
= 1: Internal voltages normal
= 1: Position error within normal range
= 1: Galvanometer scanner and servo board temperature within
normal range
= 1: Booting process completed
= 0: A critical error occurred. The system was switched into a
permanent error state.
= 0: The external power supply voltages have – at least temporarily
– dropped below the allowed value
= 0: The temperature in the scan system exceeds the maximum
allowed value. The system was switched into a temporary error
state.
= 1: The AD converter was successfully initialized
= 0: The galvanometer scanner has reached a critical edge position
= 1: All control parameters valid
®
Reserved (for intelliWELD : 1 = currently no INTERLOCK error)
®
Reserved (for intelliWELD : 1 = The sensor board was recognized)
Reserved
= 1: The control is activated, as soon as all necessary flags are set
= 0
) buffered,
H
® ®
, dynAXIS XS and
246