Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 365

Ctrl Command measurement_status
Function returns the status of a measurement session started via
the current position of the measurement pointer.
Call
measurement_status( &Busy, &Pos )
Returned
Busy
parameter
values
Pos
Comments • If a measurement session started with
then Pos+1 indicates the number of recorded data pairs up to termination (maximum
20
2 for set_trigger, maximum 2
• Pos = 2
load_program_file.
• Stored data can be queried with get_waveform.
• The status of a measurement session will reset via set_trigger(Period = 0),
set_trigger4(Period = 0),
comments).
® ®
RTC 4 RTC 5 unchanged functionality
Version info Last change with version DLL 516, OUT 515
References set_trigger .set_trigger4
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
measurement status as a pointer to an unsigned 32-bit value:
> 0: a measurement session is currently in progress
= 0: no measurement session is currently in progress
current position of the measurement pointer (within the RTC
measurement storage area) as a pointer to an unsigned 32-bit value
(0  Pos  2 20 –1 or 0  Pos  (2
19
32
–1 indicates that data recording still hasn't occurred after
stop_trigger
set_trigger
19 32
–1) or Pos = 2 –1, see below).
set_trigger or set_trigger4
for set_trigger4).
stop_execution
or (see
or set_trigger4 and
®
5's
is no longer active,
set_trigger
365