Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 615

Changes from revision 1.3 to revision 1.4
Page Name of section / command
96 chapter 7.1.3 "Marking Points"
156 chapter 8.1.5 "Jump Mode"
190 chapter 8.7.9 "Monitoring
Processing-on-the-fly Corrections"
197 chapter 8.9 "Microvector
Commands"
217 chapter "Normal, Short and Variable
List Commands and List Multi-
Commands"
240 clear_fly_overflow
270 get_jump_table command
273 get_marking_info
300 ... if_fly_x_overflow
if_fly_y_overflow
if_not_fly_x_overflow
if_not_fly_y_overflow
304 ... if_not_pin_cond
if_pin_cond command
317 list_continue command
335 load_jump_table_offset
349 ... mark_abs command and the
corresponding _rel, _3d and para_
commands (but not the
corresponding timed commands)
365 measurement_status
366 micro_vector_abs
micro_vector_rel
405 Commands for coordinate transfor-
... 475 mations: set_angle, set_angle_list,
set_offset, set_offset_list,
set_offset_xyz, set_offset_xyz_list,
set_matrix, set_matrix_list,
set_scale. set_scale_list
425 set_fly_limits command
436 set_jump_mode
438 set_jump_mode_list
439 set_jump_table command
498 set_vector_control
®
RTC 5 PC Interface Board
Rev. 1.9 e
18 Revision History
Change
Added (as of version OUT 527): Marking points via mark or
arc commands of zero length
Added
revisions and additions to the section
Monitoring Area and Conditional Command Execution (as of
Version DLL 525, OUT 527)"
Added
Added (as of version DLL 525, OUT 527): Postponing short
list commands via
command Added
Added
command Change (as of version DLL 525, OUT 527): bits#4...7
command, Added
command,
command,
command
command, New note about reliable usage
Added
command Added
Change (as of version OUT 527): A mark of zero length only
does not change the laser control signals if it occurs within a
polyline (see
command Added: Pos = 2
command, Added
command
Changed: behavior for at_once = 3 (here the laser control
signals remain unaffected)
Added
command Added
command Added
Added
command Change (as of version DLL 525, OUT 527): Variation of the
focus shift with Ctrl = 7
"Customer-Defined
list_continue (alternative to list_nop)
page 213
page 102).
32
–1
615