Scanlab RTC 5 PC Interface Board Installation And Operation Manual page 563

Ctrl Command select_list
Support status This RTC
® ®
RTC 4 RTC 5 select_list(0) can be replaced by set_extstartpos(0), select_list(1) by
set_extstartpos(Mem1). Thereby, Mem1 is the memory size of "List 1" (and the absolute start
address of "List 2"). After initialization (with load_program_file), Mem1 is 4000, otherwise
as set via config_list. Mem1 can be determined (e.g. after a board changed "ownership")
via set_start_list_2
Ctrl Command set_base
Support status This RTC
Replaced by There is no equivalent command for the RTC
whose base address is automatically set).
Ctrl Command set_co2_standby
Support status This RTC
Replaced by set_standby (see page 488)
List Command set_co2_standby_list
Support status This RTC
Replaced by set_standby_list (see page 489)
List Command set_delays
Support status This RTC
Replaced by set_laser_delays (page
List Command set_encoder_values
Support status This RTC
Replaced by set_fly_x (page
Ctrl Command set_gain
Support status This RTC
Replaced by set_matrix (page
Ctrl Command set_list_mode
Support status This RTC
® ®
RTC 4 RTC 5 See "Circular Queue Mode", page
®
RTC 5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
® ® ®
2/RTC 3/RTC 4 command is not supported by the RTC
and get_input_pointer.
®
2 command is not supported by the RTC
®
2 command is not supported by the RTC
®
2 command is not supported by the RTC
®
2 command is not supported by the RTC
442), set_scanner_delays (page 475)
®
2 command is not supported by the RTC
429), set_fly_y (page 431)
®
2 command is not supported by the RTC
449), set_offset (page 463)
® ®
3/RTC 4 command is not supported by the RTC
82.
®
5.
®
5.
®
5 (because it is a plug-and-play board
®
5.
®
5.
®
5.
®
5.
®
5.
®
5.
563