Advanced Functions For Scan Head And Laser Control; Idrive ® Functions; Transfer Protocol - Scanlab RTC 5 PC Interface Board Installation And Operation Manual

8

Advanced Functions for Scan Head and Laser Control

®
8.1 iDRIVE Functions
®
SCANLAB's iDRIVE scan systems (intelliSCAN
®
intelliSCAN , intelliDRILL
de
®
intelliWELD , varioSCAN ) utilize the company's
de
®
iDRIVE technology. This new servo and control
approach exploits the advantages of fully digital
servo electronics to deliver significantly expanded
functionality. An enhanced transfer protocol
between the servo electronics and the controller facil-
itates support of all the new features (also see the
following section).
As a result, scan systems with iDRIVE
allow to configure a number of settings. The user can
for example
• select the data type to be transmitted from scan
system to the controller,
• select an appropriate dynamic configuration
(tuning),
• set a desired PosAcknowledge threshold value,
• change the scan system's effective calibration,
• configure the scan system's start behavior or
• perform a fault diagnosis or verify intact data
transfer capability.
®
With an RTC 5, most iDRIVE
executed via control_command. During this
command's execution, no position data will be trans-
®
mitted from the RTC 5 to the scan system. As a
result, the galvanometer scanners' movements might
briefly be interrupted. However, for scan systems
with SL2-100 interfaces (operated without an
XY2-100 converter) specific iDRIVE
executed via the command
neously to normal communication, such that neither
the transmission of position data nor the movements
of the galvanometer scanners will be interrupted.
®
All iDRIVE functions are described in the following
sections.
®
RTC 5 PC Interface Board
Rev. 1.9 e
8 Advanced Functions for Scan Head and Laser Control
®
,
® ®
, intellicube ,
®
functionality
®
functions can be
®
functions can be
send_user_data simulta-

8.1.1 Transfer Protocol

Data transfer between RTC
follows the SL2-100 protocol, which supports the full
®
functionality of iDRIVE technology. With iDRIVE
scan systems this protocol allows, for example, status
signals of the X and Y axes to be separately and simul-
taneously evaluated. For a 3D scan system, Z-axis
status signals can be simultaneously queried via the
channel of the scan head connector to which the Z-
axis is connected.
SCANLAB's XY2-100 converter can be used for
®
iDRIVE scan systems equipped with a conventional
XY2-100 or XY2-100 Enhanced interface. It converts
®
the RTC 5's SL2-100 control signals into XY2-100-
conformant signals and the scan system's XY2-100
status signals into SL2-100-conformant signals (see
page 42). This conversion supports the full function-
®
ality of iDRIVE technology on previous XY2-100-
based scan systems.
SL2-100-equipped scan systems can only be
®
controlled via an RTC 5 without a converter.
®
5 and scan systems
®
152