Group 8
6.5 Basic operating procedures
This paragraph describes the basic operating procedures of the Leibinger JET3 series printers.
6.5.1 General
The complete control of the printers can be carried out with a connected PC-mouse or
directly with the TFT-Touch-Display.
For the operation with the Touch-Display the control of the device happens by a slight
touch on the buttons (touch-fields) with the finger or with the touch pin (included in the
delivery). Here the targeted precision is decisive and not the pressure.
The operation with the touch-display is described subsequently.
Attention
If you touch the screen inadvertently it may have uninteded
consequences.
6.5.2 First initialization of the device
After connection to the mains power or after a power interruption, the initialization of the
device will be carried out automatically. The progress of the initialization is shown by a
bar. After finishing the process the device is switched to the standby-mode (monitor is
dark) and the printer is now ready to switch on by pressing the touch screen.
Figure 22
Initialization process
1 – Progress bar
JET3 Series
Job Editor
Page 75
1
Release 2.02