Table of Contents
Advertisement
Group 6
6.3 Operating procedures and operating
elements
6.3.1 LCD touch display
6.3.1.1 Switching on/switching off procedure
Figure 14
The LEIBINGER-JET 2 is switched on by
touching any point of the touch display (1)
that is still dark. Contact duration approx. 2
sec.
The start screen with the software-version
number (2) and the execution identification
(3) are displayed for 3 sec..
Information about execution
identification:
64 = Actual frequency 64 KHz
96 = Actual frequency 96 KHz
n = for non-pigmented ink
p = for pigmented ink
The entire control is performed via the
touching of the touch fields. The fields are
activated by light touching with the finger or
the touch pen (included in the scope of
delivery) whereby the precision and not the
pressure is decisive.
Only fields with bold frames are active and
operable. Thinly edged fields (buttons) are
currently not operable.
Now the device starts automatically with
the bleeding of the system. The bleeding
lasts between 1-5 minutes. During the
procedure
the
flashes in the status line (4). The bleeding
procedure is ended by pressing
the status line. Following ending or after cancelation of the bleeding the status display
(3) of the device alters (see following figure).
Release 3.00
Operation – procedures and elements
notification
"BLEED"
Page 47
2
Leibinger-Jet 2 se
3
4
[E0]
Advertisement
Table of Contents
