Measures In The Event Of Accidental Release (Spillage) - Leibinger JET3 Series Operating Manual
Hide thumbs
Also See for JET3 Series:
- Operating manual (378 pages) ,
- User manual (233 pages) ,
- Service manual (6 pages)
Table of Contents
Advertisement
Group 3
3.4 Measures in the event of accidental release (spillage)
GENERAL
PRECAUTIONARY
MEASURES
ENVIRONMENTAL
PROTECTION
MEASURES
RESTORATION
JET3 Series
Accident prevention
Spilled ink and solvent should be removed immediately. Used wiping
material could pose a potential fire hazard and have to be disposed in
accordance with the regulations.
Switch off sources of ignition and ventilate room. Keep personnel that
is not absolutely necessary away. Do not inhale any vapour. Observe
the protective measures listed.
DO NOT allow to enter waste water channels or waters.
Should the product enter waste water channels or the drainage
system the local water supply authority must be informed
immediately. In the event of contamination of streams, rivers or lakes
inform the national water authorities. Vapour is heavier than air and
can spread out on the ground. In combination with air it can form an
explosive mixture.
Restrict and suck up spilled substances with a non-combustible
absorbent material (e.g. sand, earth, vermiculite, infusorial earth) and
collect in a suitable container for removal. Preferably clean areas with
spilled substances with a detergent. Avoid solvents.
Page 31
Release 2.02
Advertisement
Table of Contents
