Error Config - Leibinger JET3 Series Operating Manual

Page 144

7.3.1.11 Error Config

The tab <Error Config> provides several functions for a customized error messages
management.
It is possible to declare the type of message for certain messages. For the declaration
there are three types predefined:
 Information
 Warning
 Error
The default setting is <Error> for all messages listed. The declaration defines which digital
output will be activated in case the respective message occurs. Please see chapter
7.3.3.2 Digital Outputs for details about the assignment of messages to digital outputs.
It is only possible to assign messages which are declared either as <Error> or as
<Warning> to a digital output. A message declared as <Information> will cause no
further reaction and has only to be confirmed.
Caution
Depending on the settings of the digital outputs <Error> and <Warning>
messages may trigger digital signals on certain outputs.
Check all seetings and connections of the printer before putting it into
operation.
The settings for the error and warning messages and the respective
digital signals are safety-relevant. Make sure that all declarations and
assignments are carried out in an appropriate manner.
Proceeding:
From the <Basic settings> dialog box (1): select the <Error Config> (2) tab.
All messages available for a customized configuration are listed with message code (3)
and the message itself (4). When this list is opened for the first time all messages are
declared by default as errors (5).
In order to change the declaration click on arrow of the drop-down list. The drop-down list
provides 3 options (6):
 Information
 Warning
 Error
An option is selected by clicking on it (7).
All changes have to be confirmed with a click on the <OK> button (8). In order to discard
all changes click the <Cancel> button (9).
The Example (10) shows how the error configurations interact with the settings in the I/O
dialog box.
Release 2.02
Job Editor Group 8
JET3 Series