Touch-Calibration; Figure 108 Touch-Calibration - Leibinger JET3 Series Operating Manual

Group 8

7.5.9 Touch-Calibration

The function provides a calibration of the TFT-Touch-Display. The device is delivered
with a calibrated touch display. After the calibration process is started just follow the
instructions on the display.
Figure 108 Touch-calibration
1 – Drop-down menu <Extra>
2 – Open <Touch Calibration>
3 – Calibration window
4 – Calibration point
To avoid faulty operation you have to carry out the calibration carefully!
Proceeding:
 Press the button <Extra> (1) and the option <Touch Calibration> (2).
 The calibration window (3) pops up.
 Now press carefully on the middle of the calibration point (4). Repeat the process as
long as the calibration point moves on the display.
 If the settings are calculated an according message (5) is displayed. Follow the
instructions.
 The message <Touch calibration successfully> (6) pops up.
 Finally press the button <OK> (7) to finish the process.
JET3 Series
Job Editor
1
2
4
5
5 – Message <Settings have been measured>
6 – Message <Touch calibration successfully>
7 – <OK> Button
ATTENTION
3
4
Page 219
6
7
Release 2.02