Leibinger JET3 Series Operating Manual page 337

Group 8
The current display buffer will be printed with each PrintGo signal received unless you
have selected the <Check Double Prints> option.
With the <Check Double Prints> option activated you will receive an error message
when a PrintGo signal occurs before a new character string was received. So it is granted
that each character string is only printed once.
The following tables show the data transmission, the buffer content and the print-out. It
also shows how the settings for the wildcards and the offset affect the displayed
characters and therefor the print-out.
The external data can be sent with any terminal software like e.g. Hyperterminal. You
have to make sure that the serial interface parameters of the terminal software
correspond with the parameters of the Printer interface.
Deleting the input buffer
The current content of the input buffer can be deleted at any time. For this you can use
the respective option in the Drop-down menu <Extra>:
<Extra>-<Production counter>-<ExternText Delete extern text memory>
Deleting the input buffer
JET3 Series
Job Editor
After the input buffer was deleted it has to
be filled up again completely with data.
Only then the data will be transferred to
the display buffer in order to be printed.
Page 335
Release 2.02