Date Change Offset; Figure 159 Date Change Offset Tab - Leibinger JET3 Series Operating Manual

Group 8

8.5.4 Date change offset

With this function you can shift the date change to an earlier or later point in time.
Note: The shifting happens in hours- and minutes. The max. possible offset is +/- 23
hours and 59 minutes.
Figure 159 Date change offset tab
7
8
1 – <Date change parameter> tab
2 – <+/-> drop-down list
3 – Arrow keys
4 – Input field <Offset time>
5 – <OK> Button
6 – <Cancel> Button
7 – Positive <Offset>
Proceeding:
 Select the <Date change Parameter> tab (1).
 Select in the <+/-> drop-down list (2) the kind of offset. <+> stands for a positive
offset (7). The date change is shifted to a later point in time. <-> stands for a
negative offset (8). The date change is shifted to an earlier point in time.
 Select the hour (9) or the minute block (10) in the input field (4) for the <Date change
offset> (13).
 The <Date change offset> is set with the two arrow keys (3). The left arrow key will
decrease the <Offset> the right arrow key will increase the <Offset>.
 All settings are confirmed with the <OK> button (5).
 With the <Cancel> button (6) the tab is closed without saving.
JET3 Series
Job Editor
2
5
9 10
13
8 – Negative <Offset>
9 – Offset <Hour block>
10 – Offset <Minute block>
11 – <Decrease>Offset
12 – <Increase>Offset
13 – Adjusted <Date change offset>
Page 285
1
3
4
6
11 12
Release 2.02