Create New Job Lists - Example : Job Organisator - Leibinger JET3 Series Operating Manual
Hide thumbs
Also See for JET3 Series:
- Operating manual (378 pages) ,
- User manual (233 pages) ,
- Service manual (6 pages)
Table of Contents
Advertisement
Group 8
7.2.5.4 Create new job lists – Example : Job organisator
Task:
Three different print jobs shall be printed (Job1 to Job3) using the job list type <Job
organisator>. The whole print list shall be printed twice. The second printout shall be in
a distance of 150 mm after the
Important: The <Job Organisator> offers the possibility to define the number of
repetitions with <PrintGo repeat> and the <PrintGo distance> for the repetitions and
for the complete job list. All settings for these parameters made within each print job will
be ignored in the job list.
The only exception is the first print job imported to the list. The parameters for <PrintGo
distance> and <PrintGo repeat>.of this print job will be applied for the job list <PrintGo>
settings. Nevertheless these parameters can be adjusted in the job list settings even after
the first job was imported.
Beside these parameters the settings for <PrintGo Control> and <StrokeGo Control>
are also taken from the first print job imported. These parameters cannot be adjusted
within the <Joblist Settings>. Changes are only possible by deleting all jobs on the
job list and importing the first job again.
The <PrintGo> signal sets the reference point for all distances assigned to the print jobs
on the job list. The distances to be assigned for each print job on the job list, the <PrintGo
distance> for the job list and the number of repetitions of the job list are shown in the
table below:
Job list parameters
Job
Print
no.
job
1
Job1
2
Job2
3
Job3
Complete job list
JET3 Series
<PrintGo> signal.
Distance [mm]
<PrintGo distance>
30
70
110
Job Editor
job list [mm]
---
---
---
150
Page 113
<PrintGo repetition> job
list
---
---
---
1 printout
1 repetition
Release 2.02
Advertisement
Table of Contents
