Leibinger JET3 Series Operating Manual page 214

Page 212
2. Deletion of graphic elements:
(Example: On side of a rectangle and a complete line shall be deleted)
Proceeding:
 Start with the deletion of the line.
 Select the <Selection> tool (2) from the the <Function> drop-down menu (1).
 The selection frame is defined by two corner points (3) and (6) . Place the corner
points in a way that the selection frame covers the line to be deleted.
 The <Coordinates> indicator (4) displays the respective positions of the corner
points. The <Status bar for the current tool> (5) provides information for each
step.
 Select the <Delete> tool (8) from the <Edit> drop-down menu (7) .
 The line covered by the selection frame will be deleted.
 In the next step one side of the rectangle will be deleted.
 Select the <Selection> tool (2) from the <Function> drop-down menu (1).
 Define the first corner point for the selection frame (11). At this point the contour of
the rectangle will be interrupted. This point will be marked red.
 Define the second corner of the selection frame (12). This point is positioned just
one dot below the first corner point. Actually this results not in a selection frame
but in a selection line.
 Select the <Delete> tool (8) from the <Edit> drop-down menu (7).
 The part of the rectangle covered by the selection frame will be deleted.
Release 2.02
Job Editor Group 8
JET3 Series