Group 8
8.5.3.5 Speed dependent output
In dependence of a pre-adjusted speed limit, this special output signal switches ON or
OFF. The setting for the output can be found in the main window under Settings ► I/O
Settings ► Outputs. The speed dependent output can be assigned to any available
output.
Function: The assigned output switches to high level once the set speed is reached or
exceeded. The assigned output switches back to low level when the speed
falls 10% below the set speed.
Figure 157
Speed dependent output – Settings/diagram
Assigning
dependent output function to
an available output
Please see example on the next page!
JET3 Series
the
speed
Basic function diagram
Job Editor
Page 281
Release 2.02