Group 10
10.1.7 Other servicing work
10.1.7.1 Replacement of the battery
Dangerous voltage!
Contact causes serious damage through an electric shock! Disconnect the
device from the mains supply prior to opening. Remove mains plug!
Risk of explosion in the event of incorrect replacement of the battery.
Replace only with an identical battery or with an equal value battery type
in accordance with the recommendations of the manufacturer! The
instructions of the battery manufacturer must be observed when
disposing of the battery!
This work must only be carried out by trained personnel or by Leibinger
service technicians!
The battery is situated in the electronics housing on the controller board. If necessary the
battery must be replaced. For the change of the battery you have to observe the following
safety- and disposal instructions as well as the disposal directions and the disposal
directions of the battery manufacturer!
JET3 Series
Setting-up/Maintenance
DANGER
CAUTION – RISK OF EXPLOSION
REPLACEMENT OF BATTERY
Page 371
Release 2.02