Leibinger JET3 Series Operating Manual page 340

Page 338
Setting for double prints
With the check box checked off (10) each received character string will only be printed
once. In case there is another PrintGo signal received before any new data were
received the printer will switch to <Print Stop>: the green <Print Start> button switches
off and the red <Print Stop> button switches on. Additionally a message box is
displayed:
You will have to confirm the error message and restart the print-out again by pressing
the green <Print Start> button.
Example: diagrams with and without double prints checked
With double prints not checked there will
be a printout with each PrintGo signal.
Therefore a received character string
may be printed more than once.
<Start symbol> and <End symbol>
Using a <Start symbol> and a <End symbol> allows masking a received character
string whereby the character string can be of variable length within the set limits.
A <Start symbol> is defined with the decimal value of an ASCII character. You can use
a value between 1 and 255 (13). The selected character will be shown to the right of the
arrow keys of the display field (14).
A <End symbol> (15) is defined with the decimal value of an ASCII character. You can
use number between 1 and 255. The selected character will be shown to the right of the
arrow keys of the display field (16).
Release 2.02
Job Editor
With double prints checked there will be
only one print-out with each PrintGo
signal. If a second PrintGo signal occurs
before new data were received will an
error message will be displayed.
Therefore a received character string is
always printed once only.
Group 8
JET3 Series