Leibinger JET3 Series Operating Manual page 109
Hide thumbs
Also See for JET3 Series:
- Operating manual (378 pages) ,
- User manual (233 pages) ,
- Service manual (6 pages)
Table of Contents
Advertisement
Group 8
7. With the next <PrintGo> signal the addressed print job will be printed. For this
print job the <PrintGo delay> is set to 20 mm. Therefore the printout will start 20
mm after the position where the <PrintGo> signal occurred (13). <PrintGo
repetition> is set to 3 and the <PrintGo distance> is set to 50 mm. Therefore
there will be a total of four printouts (14) and the distances between the first dots
of each printout/repetition will be 50 mm (15).
8. The print job at the fifth position of the job list shall be printed twice. Therefore the
address has not to be changed for the next print-out (16). The print job will be
printed again with the next <PrintGo> signal and it will have the same distances
between printouts as the last printout.
9. Apply the address of the print job at the first position of the job list to the X4
connector (decimal=1; 10-bit binary=0000000001 (17).
10. With the next <PrintGo> signal the addressed print job will be printed. For this
print job the <PrintGo delay> is set to 0 mm (18). Therefore the printout will start
directly with the <PrintGo> signal (19). <PrintGo repetition> is set to two and
the <PrintGo distance> is set to 60 mm. Therefore there will be a total of three
printouts (20) and the distances between the first dots of each printout/repetition
will be 60 mm (21).
11. The task is finished.
Basic rules for the job list type <Extern Job select> with distances:
An error message occurs if the set <PrintGo distance> is shorter than the printout
itself.
A single print job of the <External Job> job list can be edited directly in the joblist
editor. A click on the <Job edit> button will open the currently selected print job
in the <Job Editor>. After changes are saved in the <job editor> leave the <Job
Editor> with the <Close> in order to return to the joblist editor.
The <PrintGo Distance> is measured between the first left print dots of two
printouts.
The <PrintGo delay> is the distance between the PrintGo signal and the start of
the printout.
<PrintGo delay> and <PrintGo distance> have no effects on distances between
two print jobs of the job list but only on distances within a print job.
JET3 Series
Job Editor
Page 107
Release 2.02
Advertisement
Table of Contents
