Leibinger JET3 Series Operating Manual page 105

Group 8
Printstyle (5)
<Print height>
<Orientation>
<mirrored>
PrintGo Parameter (6)
<PrintGo Distance>
<PrintGo Repeat>
<endless>
<PrintGo Source>
<PrintStop interrupts print-
out immediately>
<PrintGo Gate>
Encoder Parameter (7)
<Encoder Source>
<Resolution>
<intern Speed>
<Encoder/Direction>
<Speed dependent output>
<lock backward>
Date Change Parameter (8)
<Date Change Offset>
6. Save the created job list (9-10).
7. Open the job list with the <Load Joblist to print> (11-12).
8. Get the printer ready to print (open nozzle seal, push green <PrintStart> button).
9. Apply the address of the print job at the first position of the job list to the X4
connector (decimal=1; 10-bit binary=0000000001) (13).
10. With the next <PrintGo> signal the addressed print job will be printed.
11. Apply the address of the print job at the seventh position of the job list to the X4
connector (decimal=7; 10-bit binary=0000000111) (13).
12. With the next <PrintGo>signal the addressed print job will be printed.
13. Apply the address of the print job at the fifth position of the job list to the X4
connector (decimal=5; 10-bit binary=0000000101 (13).
14. With the next <PrintGo> signal the addressed print job will be printed.
JET3 Series
Job Editor
Default (80%)
Default (0°)
Default (no)
Not available for <Extern Joblist>. This para-meter
can be defined within each print job. It will only affect
print jobs with repetitions.
Not available for <Extern Joblist>. This para-meter
can be defined within each print job. Distances
between repetitions are defined with the <PrintGo
Distance> parameter within the print job.
Not available for <Extern Joblist> This para-meter
can be defined within each print job.
<Extern> and <positive edge>.
Default (no)
Default (no)
Extern
12.500
Not available if an external encoder is used
Clockwise
Not used. Default (700)
yes
Default (0)
Page 103
Release 2.02