Leibinger JET3 Series Operating Manual page 49

Group 5
Proceeding (Example: Filling of solvent)
Risk of fire and injury! Absolutely observe!
 Before filling the device with the consumables, measures for the
 Highly flammable! Burning gases and liquids may cause severe burns.
 Always statically discharge the printer and yourself before filling the
 Protective equipment is necessary! Read the safety data sheets and the
The sealing of the refill bottle must not be opened!
 Open the lid (2) of the reservoir tank unit (1).
 Open the screw cap of the solvent tank (4) and of the refill bottle (5).
 Put the refill bottle on the solvent tank. The seal of the bottle will be breached and the
closing valve of the tank will open automatically and the reservoir tank is filled up.
 Wait until the refill bottle is completely empty.
 Take out the empty refill bottle. The closing valve of the reservoir tank will be closed
automatically.
 Finally close the reservoir tank and empty refill bottle carefully with the srew caps.
The reservoir tanks as well as the empty refill bottles have to be closed
carefully after filling.
JET3 Series
Transport/Start up
WARNING
electrostatic discharge have to be made!
Keep sources of ignition away from the printer!
reservoirs! Simply touch the housing of the printer to discharge the
equipment and stand on a grounded surface wearing ESD shoes during
filling!
personal protective equipment rules and regulations!
ATTENTION
ATTENTION
Page 47
Release 2.02