Transport/Start Up; Transport, Storage, Shipping; Mounting - Leibinger JET3 Series Operating Manual

Page 36

5 Transport/Start up

5.1 Transport, storage, shipping

In order to avoid damage during transport the following instructions must be observed.
The Leibinger JET3 series printer must only be transported in a standing position. It is
packed in a cardboard box with special polystyrene inserts for safe dispatch during
delivery. Transport of the device must only be made in this packing in order to avoid
damage.
The printer should be only transported in an empty condition! A
special draining routine ("ServiceFunctions  Hydraulic  Special
Functions/ Tools  Drain Routine") is available for the draining of the
device.
Note! Storage temperatures below +5°C and above +50°C as well as
storage at outside are not admissible and can lead to damage!

5.2 Mounting

Danger of explosion!
 The device must not be operated in potentially explosive areas!
 The installation has to be carried out according to the installation
 Precautions regarding electrostatics have to be carried out!
The device must be installed in a well ventilated room only and must be
kept away from any source of heat, flame or sparks, e.g. radiant heater,
etc.!
Check device for damage! When determining a suitable place of setting up, the
necessary additional space requirement for the movement room of the operating and
service personnel must be taken into consideration. Solvents are processed in the
device, adequate room ventilation must be ensured!
Release 2.02
Transport/Start up
ATTENTION
WARNING
instructions of the manufacturer!
WARNING – INSTALLATION OF THE DEVICE
Group 5
JET3 Series