End Value; Leading Zeros (Left-Hand Zeros); Step Width; Repetitions - Leibinger JET3 Series Operating Manual
Hide thumbs
Also See for JET3 Series:
- Operating manual (378 pages) ,
- User manual (233 pages) ,
- Service manual (6 pages)
Table of Contents
Advertisement
Page 316
8.7.3.1.4 End value
The setting defines the end value of the counter. The maximum input is 10 digits.
After reaching the end value the counter will be reset to the start value.
The set value is shown on the accordant display field.
8.7.3.1.5 Leading zeros (Left-hand zeros)
With this function the display of the leading zeros of a counter are turned on or off.
Example: 4-digits counter
Function
deactivated
activated
8.7.3.1.6 Step width
The setting defines the increasing of the counter between the several prints.
The set value is shown on the accordant display field.
8.7.3.1.7 Repetitions
The setting defines the amount of prints which should be repeated. If no repetition is
requested, you have to enter „0". The counter can print up to 999998-times repetitive.
Example
0 = no repetition
:
1= Every counter value is printed twice consecutively (1repetition)
2 = Every counter value is printed triply consecutively
The set value is shown on the accordant display field.
Release 2.02
Value
Display
1
1
1
0001
(2 repetitions)
Job Editor
Group 8
JET3 Series
Advertisement
Table of Contents
