Printgo - Hold Off Distance; Figure 144 Printgo-Holdoff Distance - Leibinger JET3 Series Operating Manual

Group 8
8.5.2.4 PrintGo – Hold off distance
The setting provides a filtering of unrequested PrintGo-signals (e.g. PrintGo with bounces
or double releasing). The value defines a length „x" after the PrintGo-signal in which every
further signal will be ignored.
The delay is specified in the dimension set in the <Basic settings> e.g. in mm.
The set value is shown on the accordant display field.
Figure 144 PrintGo-holdoff distance
PrintGo with „chatters":
Filtering active
PG Signal(s)
JET3 Series
Job Editor
Double releasing:
PG Signal(s)
Printed
trigger
marks
Object which
should be printed
Page 263
Filtering active
Printed
trigger
marks
Release 2.02