Leibinger JET3 Series Operating Manual page 370
Hide thumbs
Also See for JET3 Series:
- Operating manual (378 pages) ,
- User manual (233 pages) ,
- Service manual (6 pages)
Table of Contents
Advertisement
Page 368
9. If the ink or solvent type is compatible and the bottle was successfully activated the
filling can be carried out as described in the following steps.
Before the filling process a static discharge is mandatory! For this you
have to touch the cabinet of the printer directly or you can wear ESD shoes
and make sure you stand on an a floor grounded before and during the
filling procedure!
The sealing of the refill bottle should be not opened!
Now open the red cap of the ink or solvent bottle but do not pull of or damage the
seal!
10. Fill up ink or solvent depending on the shown refilling message.
ATTENTION! Please make sure that the ink and the solvent are filled in the correct
tanks! Check the caption of the tank caps before filling!
Positions of the ink and solvent tanks
Release 2.02
Setting-up/Maintenance
Caution
Inflammable (Risk of fire)!
Combustible gases and liquids cause serious burns.
Sources of ignition must be kept away from the device!
Attention
Reservoir tank „Ink" – at the back
Reservoir tank „Solvent" - at the front
Group 10
JET3 Series
Advertisement
Table of Contents
