Counter Increment (Methods); Figure 171 - Counter Settings - Increment Methods - Leibinger JET3 Series Operating Manual

Page 318
 Reset2 on X4: The reset happens by an external supplied signal on the X4 interface.
The actual input has to be assigned in the I/O Settings dialog box (Settings – I/O
Settings – Inputs)
 A counter reset method can be assigned to more than one counter. Therefore it is
possible to create "Reset groups".
Example for "Reset groups" – 6 defined Counters assigned to three groups
Counter
Counter 1
Reset external
Assignment
Pin
X 4.1 fixed
Assignment
X4

8.7.3.1.11 Counter increment (methods)

With the drop-down list <Counter Increment> you can determine the method at which
event the counter value should be changed (incremented or decremented).
Figure 171 Counter settings - Increment methods
 with PrintGo:
The change in value of the counter happened with each the PrintGo-signal (even, if
the printout is stopped and the printer still receives some PrintGos from the sensor
or the internal PG source).
 with printing (text) end:
The change in value of the counter happens after the printout was made.
 Extern (external signal):
The change in value happens by an external signal (interface X4).
Release 2.02
Job Editor
Counter 2 Counter 3
external Reset1 on
X4
6 available inputs for
free assignment
Counter 4 Counter 5
Reset1 on Reset2 on
X4 X4
6 available inputs for free
assignment
Group 8
Counter 6
Reset2 on
X4
JET3 Series