Leibinger JET3 Series Operating Manual page 201
Hide thumbs
Also See for JET3 Series:
- Operating manual (378 pages) ,
- User manual (233 pages) ,
- Service manual (6 pages)
Table of Contents
Advertisement
Group 8
Drawing area
On the drawing area the current content of the selected ASCII character is displayed. You
can edit the character using the tools and commands from the menu bar. To change the
size of the drawing area and to set the grid you can use the options from the <View>
drop-down menu. The status bar at the bottom side of the drawing area displays
instructions for the current tool or command. There are x-y indicators in the lower right
corner of the font editor. They show the position of the point in the drawing area on which
was clicked last.
1
5
Example:
First you draw a rectangle using the rectangle tool (1 to 3). Then you select the
rectangle with the selection tool (4). The selection tool creates a red frame (5).
At last you use the <Delete> command to delete the selected area (6-7).
Command buttons
1
JET3 Series
Job Editor
2
6
2
3
3
7
4
Page 199
4
5
6
Release 2.02
Advertisement
Table of Contents
