Leibinger JET3 Series Operating Manual page 60

Page 58
Basic data /Recommended working conditions:
Signal
All signals
Increment Counter/
Reset Counter
Power ON
Jobselect 0-9
Input 0-5
In the following table you will find the minimum pulse widths which are required to release
the assigned function at the X4 plug.
Function
Open nozzle
Close nozzle
Print start
Print stop
Turn off printer
Mirrored horizontally
Gauger synchronization signal
The function allocations of the inputs 0 up to 5 happens by the software of
the the printer in the menu
Settings  I/O-Settings  Inputs.
You will find a circuit diagram of the interface in the manual appendix!
(1) all 24V power supply outputs on X1, X3, X4 and X5 are distributed over a common resettable fuse
with 700mA max. current.
Please ensure that the sum of current are not exceed 700 mA.
(2)
If one or more of the jobselect inputs were changed the changes must be completed
( = all signals are stable) within this time.
Release 2.02
Transport/Start up
Parameter
Input level High
Input level Low
Input resistance
Minimum pulse width
Minium pulse width
Maximum duration
of bounce
Minimum pulse widths
Minium pulse width
300ms
300ms
500ms
500ms
750ms
200ms
200ms
INFORMATION
Value
15 up to 30V
-3,5V up to 3,5V
(or high resistance)
6,8kOhm
2 ms
2,5 s
10 ms (2)
Depending on assigned function
(see following table)
Group 5
JET3 Series