Page 1
S E R V I C E - D O C U M E N T A T I O N Deplete Routine for JET3 1. Switch on the JET3 and wait while the system is bleeding. 2. Touch the icon „wrench“ and switch off the “Control (Regelung)”-button.
Page 2
S E R V I C E - D O C U M E N T A T I O N 4. Remove the return flow tube on the blue tube connector and connect a pice of tube on this connector (please see the following pictures).
Page 3
S E R V I C E - D O C U M E N T A T I O N Please confirm with "OK". The menu will change back to "special functions / tools" The drained ink from the system can be used again if required. 6.
Page 4
S E R V I C E - D O C U M E N T A T I O N Confirm with "OK" and the menu changes back to "special functions / tools". The drained solvent should not be used any more further, because it is strongly mixed with ink.
Page 5
S E R V I C E - D O C U M E N T A T I O N 8. Switch off the JET3 with the function "emergency off (Notabschaltung)" and plug out the printer from the mains supply.