Leibinger JET3 Series Operating Manual page 253

Group 8
Text object for the Leibinger logo.
Counter object for the printout control of
the Leibinger logo.
This counter is assigned to the text
object "Leibinger".
It is displayed in green because it will
not be printed. When you select the
counter object you can see its ID in the
field below the x-y coordinates.
Counter parameters
Printout control of Leibinger logo
1. The counter works with 1 digit and a
step width of 1; left-hand zeros are
not relevant.
2. The count will start at 1 and the end
value is 3. After reaching the end
value the counter will loop back to 0.
3. The current counter value is not
printed.
1. In the global settings of the text
object you can assign the counter for
the Liebinger text object. Make sure
to set the correct ID.
2. The Leibinger logo shall be prin-ted
between two length specifi-cations.
Therefore the distance between the
printout of the length specifications
and the Leibinger logo has to be
500 mm. The position of an object
can be exactly specified in the job
editor. The x value equals the
number of strokes. The mm value of
one stroke can be found in the font
parameter menu. In this example
the stroke width is set to 0,271
mm/Stroke. This equals in ~1852
strokes for 500 mm.
JET3 Series
Job Editor
„Leibinger logo group"
Picture 6 –
Printer job editor: Objects for the
„Leibinger" logo printout
Picture 7 – Counter settings for the
Picture 8 – Settings for the
Picture 9 –
Use the scroll bar for switching
between the 2 "object groups"
within the editor
Page 251
Open the "Global
settings" menu of
the selected object
Leibinger text object
"Leibinger" text object
Release 2.02