Stop After X Products - Pre-Defined Print Stop - Leibinger JET3 Series Operating Manual
Hide thumbs
Also See for JET3 Series:
- Operating manual (378 pages) ,
- User manual (233 pages) ,
- Service manual (6 pages)
Table of Contents
Advertisement
Group 8
7.5.2.1 Stop after x products - Pre-defined print stop
With the option <Stop after x Products> the amount of prints will be defined after the
LEIBINGER Printer should release an automatic print stop.
If a print stop has been pre-defined the value is displayed in the status field <Production
Counter> of the main window.
Before the re-start of the production, the production counter has to be
necessarily reset to get a correct result.
Proceeding (see figure 85)85:
Press the option <Stop after x Products> (2).
The dialog box <Stop at x Products> (3) pops up.
Set the value with the Arrow keys (4). The value of the counter will be increased or
reduced in single steps by pressing the accordant buttons.
or
Click in the input field (5). The Numeric keypad (6) opens for input.
You will find further information regarding the working with Numeric
keypads in the chapter 6.4.1 Numeric keypad
Confirm the value set by pressing the <Set> button (7) or cancel the process with the
<Cancel> button (8).
The value set is displayed in the <Product Counter> status field (9) of the main
window. A pre-defined print stop setting is marked with a red frame for better for better
visualization.
If the x-value set is equal or lower than the value set for the 1. production counter the
input will be ignored.
JET3 Series
Job Editor
ATTENTION
INFORMATION
Page 183
Release 2.02
Advertisement
Table of Contents
