Ink On/Off; Extern Ink On/Off; Piezo Test And Charge Test - Leibinger JET3 Series Operating Manual
Hide thumbs
Also See for JET3 Series:
- Operating manual (378 pages) ,
- User manual (233 pages) ,
- Service manual (6 pages)
Table of Contents
Advertisement
Group 8
7.4.3.2 Ink on/off
With the two buttons <Ink on > (2) and <Ink off > (3) the ink delivery to the nozzle is
turned on or off.
The status of the ink delivery is designated by a
This function can be generated also „remote-controlled" by an electronical contact (see
also the informations in the following chapter).
7.4.3.3 Extern Ink on/off
During cleaning works at the print head it can be helpful (e.g. in case of a long umbilical)
that the ink delivery can be turned on/off externally. The Printer requires impulses for the
control. This can be reached with a bridge between pin 9 and 14 and a switch contact
(push button) at the pins 21 and 13 of the I/O interface X4.
Example:
First impulse = switches off the ink delivery
Second impulse = switches on again the ink delivery
Diagram/Plug assignment:
The signal which is pending at the interface is only analyzed by the Printer if the function
<Extern Ink on/off active> (4) is turned on.
If the function is activated, it is shown by a
7.4.3.4 Piezo test and charge test
For further information please contact the Leibinger-Service Department
or your authorized dealer!
JET3 Series
Job Editor
INFORMATION
on the accordant button.
on the display.
Page 165
Release 2.02
Advertisement
Table of Contents
