Print Mode; Figure 139 - Font Parameter - Print Mode - Leibinger JET3 Series Operating Manual
Hide thumbs
Also See for JET3 Series:
- Operating manual (378 pages) ,
- User manual (233 pages) ,
- Service manual (6 pages)
Table of Contents
Advertisement
Page 258
8.5.1.4 Print mode
The print mode is selected from the <Print mode > drop-down list. There are 12 printing
modes available.
The print modes are classified in three categories: the maximum number of vertical dots
per line, the print quality and the printing speed. You can either aim for high print quality
or high speed. There are five different values for the dots and three modes for quality
respective speed available whereby not all combinations of these criteria are possible.
Available dot modes: 32, 24, 16, 12, 5 and 2-line 7x5
High quality mode:
Fast mode:
Speed mode
High speed mode:
Figure 139
Font parameters - Print mode
Release 2.02
Job Editor
This mode allows the best possible positioning of the single
dots and therefore the best possible print quality. Change to
fast mode if the required speed cannot be reached in HQ-
mode.
This mode is a good compromise between quality and
speed. Change to high speed mode if the required speed
cannot be reached in HQ-mode.
The <Speed mode> is located between the <Fast mode>
and the <High speed mode>.
This mode ensures the fastest possible print speed. The
quality of the printout is not optimal but acceptable.
Group 8
JET3 Series
Advertisement
Table of Contents
