Leibinger JET3 Series Operating Manual page 118

Page 116
Basic rules for the job list type <Job Organisator>:
 The printout of the complete job list including all repetitions is started with one
<PrintGo> signal.
 A single print job of the <Job Organisator> job list can be edited directly in the
joblist editor. A click on the <Job edit> button will open the currently selected print
job in the <Job Editor>. After changes are saved in the <job editor> leave the
<Job Editor> with the <Close> in order to return to the joblist editor.
 All distances assigned to print jobs on the job list are related to the same reference
point. The reference point is set with the <PrintGo> signal.
 If a distance assigned to a job is shorter than the sum of all distances and print
jobs lengths coming before that job no error message occurs. The too short
distance will just be ignored and the printout will start right after the last print job.
Too short distances between the print jobs on the job list, too short
distances for print jobs will lead to wrong distances for defined print job
repetitions!
 For the <PrintGo distance> which is defining the printout distance for repetitions
the same reference point is used as for the distances assigned to the print jobs
on the joblist. For each additional repetition the <PrintGo distance> is added up
respectively. Here also all defined distances will be considered.
 If the <PrintGo distance> of the job list is shorter than one complete printout of
the job list no error message occurs. The too short distance will just be ignored
and the printout of the repetition will start right after the last printout.
 The WYSIWYG preview of the main window always shows the print job that will
be printed with the next <PrintGo> signal (14).
Release 2.02
Job Editor Group 8
JET3 Series