Leibinger JET3 Series Operating Manual page 359

Group 8
Proceeding:
Example 2:
The actual counter reading of a counter object should be replaced with code. For
this each figure of the counter reading is replaced by another figure. The following
table shows the coding and an example.
Code Table
Orig. Coded
figure figure
1 0
2 9
3 8
4 7
5 6
 Select the counter object in the editing window of the job editor (2).
 First select <Format> (1) from the menu bar and then <Object> (2) from the drop
down menu. Alternatively you can use the respective direct button (3) to open the
object settings dialog box.
 The dialog box <Object Settings (Date/Time)> (5) opens.
 Select the <Replacements> tab (4)
 Select the element type „Figures" (7) from the <Type> drop down list (6).
 Each element in the <Name> list (9) has a corresponding input field in the
<Replacement> field list (8). By setting the cursor into one of the input fields a
virtual keyboard opens (10). Enter the required replacements for each element (1=0,
2=9.....7=4....etc.) (11).
 Confirm each input with the <Enter> button (12) of the keyboard.
 Fill-in each required replacement in the <Replacement> field list (13). Run through
the list by using the scroll buttons (14).
 Confirm all changes and close the dialog box with the <OK> button (15). Use the
<Cancel> button (16) to leave the dialog box without saving.
 All changes are displayed in the editing window of the <Job editor> (17).
You will find further information about the usage of the keyboard in chapter
6.4.2 Keyboard
JET3 Series
Examples
Orig. Coded Orig. figure
figure figure
Coding
6 5
7 4
8 3
9 2
Coded figure
0 1
INFORMATION
Job Editor
1587
Page 357
1 = 0
5 = 6
8 = 3
7 = 4
0634
Release 2.02