Leibinger JET3 Series Operating Manual page 275

Group 8
Example: Assumptions and pre settings for this example:
The Printer printer is used for continuously printing on a cable emerging from
a cable extruder device. The cable extruder mustn't stop even if the printout
fails. After a print interruption the printout should continue with the correct
meter number.
For this application an encoder is used for speed measuring and position
detection. The printout is carried out each meter and shows the current
number of meters.
Additionally a length measuring system has to provide a PrintGo signal after
each meter.
These settings for the so called "meter counter" are shown in Picture 13.
Picture 13 - Print parameter for Meter-Go function
Picture 14 shows the Printer editor with the counter object and the settings
for the counter object in this example. The text object for the letter "m" is
just a standard object without any special settings for this example.
Picture 14- Settings of the counter object
JET3 Series
Job Editor Page 273
Release 2.02