Encoder Parameter; Figure 154 Encoder Parameter Tab - Leibinger JET3 Series Operating Manual

Group 8

8.5.3 Encoder parameter

The printout of the LEIBINGER Printer up is composed of single dots printed in groups
of vertical lines. Such a vertical line of dots is called stroke. In order to position these
strokes a StrokeGo signal is required. The StrokeGo signal determins at which position
a stroke is printed.
Explanation:
The StrokeGo signals can be generated by an external encoder or based on time
measurments via 2 sensor signals. Alternatively the StrokeGo signals can be generated
internally by software. If the internal <StrokeGo-source> is selected additionally the
printing speed has to be defined.
The settings and parameters for all three methods are entered on the <Encoder
Parameter> tab.
The following parameters and settings are available:
 Selection of encoder signal source
 Rotating direction
 Use encoder direction for mirroring
 Lock backward on/off
Figure 154 Encoder parameter tab
1 – Check box <Encoder source int.>
2 – Check box <Encoder source ext.>
3 – Check box <Sensor Measurement>
4 – Check boxes <Encoder/Direction>
5 – Checkbox <Encoder dir. f. mirror>
JET3 Series
Job Editor
Example:
1
2
3
4
5
6
6 – Check box <lock backward>
7 – Input field <Resolution>
8 – Input field <Internal speed>
9 – Setting for <Speed dep. output>
10 – Setting for <Sensor distance>
A stroke is a complete dot line in
vertical direction (dot height).
 Resolution
 Internal speed
 Speed dependent output
 Sensor distance
Page 275
7
8
9
10
Release 2.02