Leibinger JET3 Series Operating Manual page 202

Page 200
The font editor has three command buttons in the lower right corner:
 Accept (1): With this button all changes made to the currently selected character are
confirmed and the character is applied to the opened font. All changes will be
displayed in the font preview. The font editor will remain open for further editing.
 Cancel (3): With this button you can leave the editor without saving changes made
after the last saving of the current file. The editor will be closed without further notice.
 OK (2): With this button you confirm the state of the current file. If the current file was
not already saved a message box will be displayed asking if you want to save the
current file. There are three options available:
a. Yes (4): the dialog box for saving files will be displayed
b. No (5): The message box and the font editor will be closed without saving the
current file.
c. Cancel (6): The message box will close and you will return to the font editor.
Make fonts available for the job editor
Edited or new fonts have to be loaded from the operating system before they are available
in the job editor. For this you have to reload all fonts in the software system. The command
for reloading all fonts is located in the <Extra> drop down menu (1). After the reload you
will find the new or the edited font in the font drop-down list of the job editor (4). If the
edited font is selected (2) the characters in the print job will be adjusted to the new font
(3).
An edited or a new font will not be available as long as the font is not
reloaded!
Edited or new font will NOT be re-loaded automatically!
Release 2.02
Job Editor
2
3
1
4
ATTENTION
Group 8
JET3 Series