Leibinger JET3 Series Operating Manual page 101

Group 8
Printstyle (15)
<Print height> (16)
<Orientation> (17)
<mirrored> (18)
Print Parameter (21)
<PrintGo Distance> (22)
<PrintGo Repeat> (23)
PrintGo Parameter (20)
<endless> (24)
<PrintGo Source>(25)
<PrintGo Gate> (26)
JET3 Series
Job Editor
The setting defines the distances between the drops
and therefore the print height.
All printing objects can be rotated by 180°.
All printing objects will be mirrored.
Distance between two print-outs. This option is only
available for the job list type <Job organisator>. It
refers to print-outs created by the <PrintGo Repeat>
option. Please see example.
Number of repetitions with each PrintGo signal. This
option is only available for the job list type <Job
Please see example.
organisator>.
The print-out will be carried out until a <PrintStop>
command occurs. This option is only available for the
job list type <Job organisator>.
example at the end of this chapter.
Defines the source and the edge to be evaluated of the
PrintGo signal
With this option selected an additional print start query
will be activated using a separate PrintGo Gate
sensor. The print-out will only start as long as the
monitored sensor is active. Additionally it can be
defined which kind of signal level shall be recognized
as "active".
Page 99
Please see
Release 2.02