Leibinger JET3 Series Operating Manual page 112

Page 110
Printstyle (5)
<Print height>
<Orientation>
<mirrored>
Print Parameter (6)
<PrintGo Distance>
<PrintGo Repeat>
<endless>
<PrintGo Source>
<PrintStop interrupts print-
out immediately>
<PrintGo Gate>
Encoder Parameter (7)
<Encoder Source>
<Resolution>
<intern Speed>
<Encoder/Direction>
<Speed dependent output>
<lock backward>
Date Change Parameter (8)
<Date Change Offset>
7. Save the created job list (9-12).
8. Open the job list with the <Load Joblist to print> command (13-14).
9. Get the printer ready to print (open nozzle seal, push green <PrintStart> button).
10. With the next <PrintGo> signal the first print job of the job list will be printed. There
are no repetitions defined for this print job, therefore there will be only one printout.
The <PrintGo delay>is 0 mm (13).
11. With the next <PrintGo>signal the second print job of the job list will be printed.
There are two repetitions defined, therefore there will be two more printouts with
the next two PrintGo signals. The <PrintGo delay> for each printed job is 20 mm
(13).
12. With the next <PrintGo> signal the third print job of the job list will be printed.
There is one repetition defined, therefore there will be one more printout with the
next PrintGo signal. The <PrintGo delay> for each printed job is 30 mm (13).
13. With the next <PrintGo> signal the fourth print job of the job list will be printed.
There are three repetitions defined, therefore there will be four more printouts with
the next four PrintGo signals. The <PrintGo delay> for each printed job is 20 mm
(13).
Release 2.02
Job Editor
Default (80%)
Default (0°)
Default (no)
Not available for <Batch Job>. Parameters defined
within a print job will be ignored.
Not available for <Batch Job> job list. Para-meters
defined within a print job will be ignored.
Not available for <Batch Job> job list. Para-meters
defined within a print job will be ignored.
<Extern> and <positive edge>.
Default (no)
Default (no)
Extern
12.500
Not available if an external encoder is used
Clockwise
Not used. Default (700)
yes
Default (0)
Group 8
JET3 Series