Leibinger JET3 Series Operating Manual page 117

Group 8
Printstyle (5)
<Print height>
<Orientation>
<mirrored>
Print Parameter (6)
<PrintGo Distance>
<PrintGo Repeat>
<endless>
<PrintGo Source>
<PrintStop interrupts print-
out immediately>
<PrintGo Gate>
Encoder Parameter (7)
<Encoder Source>
<Resolution>
<intern Speed>
<Encoder/Direction>
<Speed dependent output>
<lock backward>
Date Change Parameter (8)
<Date Change Offset>
7. Save the created job list (9-10).
8. Open the job list with the <Load Joblist to print> command (11-12).
9. Get the printer ready to print (open nozzle seal, push green <PrintStart> button).
10. The <PrintGo> signal sets the reference point for all distances assigned to the
print jobs on the job list. The first print job of the job list will be printed in a distance
of 30 mm to that reference point (13).
11. The second print job of the job list will be printed in a distance of 70 mm to the
reference point (13).
12. The third print job of the job list will be printed in a distance of 110 mm to the
reference point. (13).
13. In the <PrintGo Parameters> of the <Joblist Settings> parameter for <PrintGo
distance> and <PrintGo repetition> were set. The <PrintGo distance> was set
to 150 mm and there shall be one repetition. Therefore all three jobs on job list
will be printed again in the same matter as described in points 9-11. The repetition
will start 150 mm from the reference point (13).
14. The task is finished.
JET3 Series
Job Editor
Default (80%)
Default (0°)
Default (no)
150 mm
1
Not selected
<Extern> and <positive edge>.
Default (no)
Default (no)
Extern
12.500
Not available if an external encoder is used
Clockwise
Not used. Default (700)
yes
Default (0)
Page 115
Release 2.02