Group 8
7.4.4.2 Mix only ink/sovent
With the two buttons <Mix only Ink > (1) and <Mix only Solvent > (2) only ink or solvent
can be supplied to the hydraulic circuit.
These functions allow to set the viscosity of the ink fast to a lower or higher value.
The execution of addition of the selected medium is displayed by an accordant message
(3).
With the button <Stop> (4) the process will be finished.
By adding solvent the ink can be diluted too strong. Therefore this function
should only be carried out by qualified personnel.
Figure 75
Add only ink/solvent
3
1 – <Mix Ink> Button
2 – <Add Solvent> Button
3 – Message <Adding ink only>
JET3 Series
Job Editor
ATTENTION
1
2
5
4 – Message <Adding solvent only>
5 – Button <Stop>
Page 169
4
Release 2.02