Table of Contents
Advertisement
Command Reference Guide
T
C
UNNEL
ONFIGURATION
To activate the Tunnel Configuration mode, enter the interface tunnel command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface tunnel 1
(config-tunnel 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text">
on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do
on page 32
end
on page 33
exit
on page 34
shutdown
on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
bandwidth <value>
crypto map <mapname>
dial-backup commands
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password>
on page 1132
ip commands
begin on page 1134
keepalive <period> <retries>
lldp receive
on page 1152
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive]
mtu <size>
on page 1155
tunnel checksum
on page 1156
tunnel destination <ip address>
tunnel key <value>
tunnel mode gre
on page 1159
tunnel sequence-datagrams
tunnel source [<ip address> | <interface>]
61200510L1-35E
C
OMMAND
on page 31
on page 1110
on page 1113
on page 1114
begin on page 1116
on page 1151
on page 1153
on page 1157
on page 1158
on page 1160
Copyright © 2005 ADTRAN
Tunnel Configuration Command Set
S
ET
on page 1161
1109
Hide quick links:
Advertisement
Chapters
Table of Contents
