Communication Via Industrial Ethernet (Device Dependant); Mode Of Operation - Baumer VeriSens ID Series Technical Documentation Manual

15.5 Communication via Industrial Ethernet (device dependant)

It is possible to communicate with the Vision Sensor via various Industrial Ethernet protocols, such as
PROFINET or Ethernet/IP™, using a PLC.

15.5.1 Mode of operation

The data transfer protocol is determined by the Industrial Ethernet specification.
The following data can be transmitted:
- General control and status data (triggers, pass / fail, active job, etc.)
- Result data (configuration in the case of job creation via the Output process interface)
- Job parameters (configuration in the case of job creation via the Input process interface)
- Additional trigger data (data in addition to the trigger that can be transmitted for object identification)
The data will be combined into logical groups. Data transmission of each group can be secured with a
handshake.
Mapping of the data in the PLC must be planned using the manufacturer-specific tool.
Selection of the protocol can be undertaken via the Application Suite as can the relevant settings. The setting
options can be found under: Device → Device settings → Process interface.
v2.11.0-B4 336/429
Technical Documentation
VeriSens
Baumer Optronic GmbH
Radeberg, Germany
®